思科路由器静态路由表的配置
首先将网段合理分配，如下是一个实验例子。我们要实现的是对router0和router1的静态路由表的配置，具体配置步骤如下：
router0：
Router>en
Router#config t
Enter configuration commands, one per line.End with CNTL/Z.
Router(config)#int f0/0
Router(config-if)#ip add 192.168.0.2 255.255.255.0
Router(config-if)#no sh
%LINK-5-CHANGED: Interface FastEthernet0/0, changed state to up
Router(config-if)#exi
Router(config)#int f0/1
Router(config-if)#ip add 10.1.5.2 255.255.255.0
Router(config-if)#no sh
%LINK-5-CHANGED: Interface FastEthernet0/1, changed state to up
Router(config-if)#exi
Router(config)#
%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/0, changed state to up
%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/1, changed state to up
Router(config)#ip route 10.1.5.0 255.255.255.0 f0/1
Router(config)#ip route 192.168.1.0 255.255.255.0 f0/1
router1
Router>en
Router#config t
Enter configuration commands, one per line.End with CNTL/Z.
Router(config)#int f0/0
Router(config-if)#ip add 10.1.5.1 255.255.255.0
Router(config-if)#no sh u
%LINK-5-CHANGED: Interface FastEthernet0/0, changed state to up
Router(config-if)#exi
Router(config)#int f0/1
Router(config-if)#ip add 192.168.1.2
% Incomplete command.
Router(config-if)#ip add 192.168.1.2 255.255.255.0
Router(config-if)#no shu
%LINK-5-CHANGED: Interface FastEthernet0/1, changed state to up
Router(config-if)#exi
Router(config)#
%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/0, changed state to up
%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/1, changed state to up
%SYS-5-CONFIG_I: Configured from console by console
Router#confi t
Enter configuration commands, one per line.End with CNTL/Z.
Router(config)#ip route 192.168.0.0 255.255.255.0 f0/0
Router(config)#ip route 10.1.5.0 255.255.255.0 f0/0
按照上述的步骤配置完成后，可以在pc0上面执行ping命令：
ping 192.168.1.1
发现能ping通，说明配置成功
版权声明：本文为博主原创文章，未经博主允许不得转载。
页:
[1]