mysql keepalived安装配置步骤
//keepalived安装配置步骤1. 安装keepalived步骤（server6、 server7上都要安装）：
wget http://www.keepalived.org/software/keepalived-1.1.19.tar.gz
tar zxvf keepalived-1.1.19.tar.gz
cd keepalived-1.1.19
yum -y install openssl-devel
./configure --prefix=/usr/local/keepalived
make
make install
cp /usr/local/keepalived/sbin/keepalived /usr/sbin/
cp /usr/local/keepalived/etc/sysconfig/keepalived /etc/sysconfig/
cp /usr/local/keepalived/etc/rc.d/init.d/keepalived /etc/init.d/
mkdir /etc/keepalived
cd /etc/keepalived/
2. keepalived的配置
配置server6的keepalived配置文件/etc/keepalived/keepalived.conf（/etc/keepalived/里面没有文件，需要新编辑一个）
vi /etc/keepalived/keepalived.conf
bal_defs {
notification_email {
wuweina@tonglukuaijian.com
}
notification_email_fromwuweina@tonglukuaijian.com
smtp_server 127.0.0.1
smtp_connect_timeout 30
router_id test1
}
vrrp_instance VI_1 {
state MASTER
interface eth1
virtual_router_id 51
priority 100
advert_int 1
smtp_alert
authentication {
auth_type PASS
auth_pass 123
}
virtual_ipaddress {
192.168.10.170
}
}
server7的配置：
keepalived配置文件/etc/keepalived/keepalived.conf，内容如下：
vi /etc/keepalived/keepalived.conf
bal_defs {
notification_email {
wuweina@tonglukuaijian.com
}
notification_email_fromwuweina@tonglukuaijian.com
smtp_server 127.0.0.1
smtp_connect_timeout 30
router_id test2
}
vrrp_instance VI_1 {
state MASTER
interface eth1
virtual_router_id 51
priority 80
advert_int 1
smtp_alert
authentication {
auth_type PASS
auth_pass 123
}
3. 启动keepalived:
在server6、server7上执行如下命令启动：
# /etc/rc.d/init.d/keepalived start ---OK
Starting keepalived: [ OK]
4. 测试
//启动虚拟的10.170IP通过8066端口连接成功，即表示整个环境搭建成功。
# mysql -uroot -proot -h192.168.10.170 -P8066
Welcome to theMySQL monitor.Commands end with ; or\g.
Your MySQLconnection id is 2719739
Server version:5.1.45-mysql-amoeba-proxy-2.1.0-RC5
Copyright (c)2000, 2011, Oracle and/or its affiliates. All rights reserved.
Oracle is aregistered trademark of Oracle Corporation and/or its
affiliates. Othernames may be trademarks of their respective
owners.
Type 'help;' or'\h' for help. Type '\c' to clear the current input statement.
mysql>
备注：最后记得将所有的启动命令都写到/etc/rc.local文件中去，实现开机启动！
版权声明：本文为博主原创文章，未经博主允许不得转载。
页:
[1]