gscuedcgco 发表于 2016-6-5 09:48:55

Cisco交换机常用配置命令

  1、配置IP地址
  交换机要能够被网管,必须给它标识一个管理IP地址,默认情况下CISCO交换机的VLAN 1为管理VLAN,为该VLAN配上IP 地址,交换机就可以被网管了。命令如下:
  a、进入全局模式: Switch#configure terminal
  b、进入VLAN 1接口模式:Switch(config)#interface vlan 1
  c、配置管理IP地址:Switch(config-if) # ip address
  如果当前VLAN 不是管理VLAN ,只需要将上面第b处命令的vlan的号码换成管理VLAN的号码即可。
  2、打开SNMP协议
  a、进入全局模式: Switch#configure terminal
  b、配置只读的Community,产品默认的只读Community名为public
  Switch(config)#snmp-server community public ro
  c、配置可写的Community,产品默认的可写Community名为private
  Switch(config)#snmp-server community private rw
  3、更改SNMP的Community密码
  a、将设备分组,并使能支持的各种SNMP版本
  Switch(config)#snmp-server group qycx123 v1
  Switch(config)#snmp-server group qycx 123 v2c
  Switch(config)#snmp-server group qycx123 v3 noauth
  b、分别配置只读和可写community 如:
  Switch(config)#snmp-server community qycx123 ro
  Switch(config)#snmp-server community qycx123 rw
  4、保存交换机配置
  Switch#copy run start
  常用命令
  1、设置交换机密码
  a、更改远程TELNNET密码
  Switch#configure terminal
  Switch(config)#line vty 0 4
  Switch(config-line)#password qycx123
  Switch(config-line)#login
  Switch(config-line)#exit
  b、更改进入全局配置模式时的密码
  Switch#configure terminal
  Switch(config)#enable secret qycx123
  2、创建并划分VLAN
  a、创建VLAN
  Switch#vlan database
  Switch(vlan)#vlan 99 name office
  (创建vlan 99 并命名为office)
  b、将端口划分至vlan
  Switch(config)#interface fastEthernet 0/8
  Switch(config-if)#switchport mode access
  Switch(config-if)#switchport access vlan 99
  (将8号快速以太口划分至vlan 99)
  3、常用调试命令
  a、显示所有配置命令:Switch#show run
  b、显示所有接口状态:Switch#show ip int brief
  c、显示所有VLAN的信息:Switch#show vlan brief
页: [1]
查看完整版本: Cisco交换机常用配置命令