H3C交换机配置端口聚合
配置vlanvlan 10 to 20
采用动态聚合模式：创建二层聚合接口，并配置动态聚合模式
interface bridge-aggregation 1
link-aggregation mode dynamic
quit
# 分别将端口GigabitEthernet1/0/1至GigabitEthernet1/0/3加入到聚合组1中。
interface gigabitethernet 1/0/1
port link-aggregation group 1
quit
interface gigabitethernet 1/0/2
port link-aggregation group 1
quit
interface gigabitethernet 1/0/3
port link-aggregation group 1
quit
# 配置二层聚合接口1为Trunk端口，并允许VLAN 10和VLAN 20的报文通过。
interface bridge-aggregation 1
port link-type trunk
port trunk permit vlan 10 20
Please wait... Done.
Configuring GigabitEthernet 1/0/1... Done.
Configuring GigabitEthernet 1/0/2... Done.
Configuring GigabitEthernet 1/0/3... Done.
quit
2. Switch B的配置
Switch B上的配置与Switch A完全相同，此处不再赘述。
两个交换机连接网线
display link-aggregation verbose
页:
[1]