cisco路由器基本实验之四 动态路由之IGRP协议的配置（Boson NetSim）
Router>Router>en
Router#conf t
Enter configuration commands, one per line.End with CNTL/Z.
Router(config)#interface e0
Router(config-if)#ip address 192.168.1.2 255.255.255.0
Router(config-if)#no shut
%LINK-3-UPDOWN: Interface Ethernet0, changed state to up
Router(config-if)#interface s0
Router(config-if)#ip address 192.168.2.1 255.255.255.0
Router(config-if)#clock rate 6400
Router(config-if)#no shut
%LINK-3-UPDOWN: Interface Serial0, changed state to up
Router(config-if)#exit
%LINK-3-UPDOWN: Interface Serial0, changed state to down
%LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0, changed state to down
Router(config)#router igrp 100 //在igrp协议名后面需要写上as号，同一自治域内的路由器才能交换路由信息，此处约定为100
Router(config-router)#network 192.168.1.0 //同rip，也要写上直连网络，非以太网还要写上neighbor(邻接路由器的相邻端口IP地址)
Router(config-router)#network 192.168.2.0
Router(config-router)#exit
Router(config)#hostname router1
router1(config)#exit
router1#copy running-config startup-config
Destination filename ?
Building configuration...
页:
[1]