457475451 发表于 2018-7-12 09:52:41

cisco交换机通过命令行查看光纤接口类型

Hardware is Gigabit Ethernet, address is 0007.8549.d0d9 (bia 0007.8549.d0d9)  MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,

  >  Encapsulation ARPA, loopback not set
  Keepalive not set
  Auto-duplex (Full), 1000Mb/s, media type is LX
  output flow-control is off, input flow-control is off
  ARP type: ARPA, ARP Timeout 04:00:00
  Last input 00:00:00, output 00:00:03, output hang never
  Last clearing of "show interface" counters never
  Queueing strategy: fifo
  Output queue 0/40, 0 drops; input queue 0/75, 0 drops
  5 minute input rate 2527000 bits/sec, 533 packets/sec
  5 minute output rate 2652000 bits/sec, 505 packets/sec
  38040353 packets input, 3467203172 bytes, 0 no buffer
  Received 2032203 broadcasts, 0 runts, 0 giants, 0 throttles
  0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
  0 watchdog, 1331313 multicast, 0 pause input
  639397853 packets output, 1844415782 bytes, 0 underruns
  0 output errors, 0 collisions, 4 interface resets
  0 babbles, 0 late collision, 0 deferred
  0 lost carrier, 0 no carrier, 0 pause output
  0 output buffer failures, 0 output buffers swapped out
页: [1]
查看完整版本: cisco交换机通过命令行查看光纤接口类型