Cisco 路由器的 IOS
Router>enable Router#reloadProceed with>
00:01:04: %SYS-5-RELOAD:> System Bootstrap, Version 11.3(2)XA4, RE LEASE SOFTWARE (fc1)
Copyright (c) 1999 by cisco Systems, Inc.
TAC:Home:SW:IOS:Specials for info
PC = 0xfff0a530, Vector = 0x500, SP = 0x680127b0
C2600 platform with 24576 Kbytes ofmain memory
PC = 0xfff0a530, Vector = 0x500, SP = 0x80004684
monitor: command "boot" aborted due to user interrupt
rommon 1 > confreg
Configuration Summary
enabled are:
load rom after netboot fails
console baud: 115200
boot: image specified by the boot&n bsp;system commands
or default to: cisco2-C2600
do you wish to change the conf iguration? y/n : y (选择 yes)
enable "diagnostic mode"? y/n : n (选择 no)
enable "use net in IP bcast ad dress"? y/n : n (选择 no)
disable "load rom after netboot fails"? y/n : n (选择 no)
enable "use all zero broadcast"? y/n : n (选择 no)
enable "break/abort has effect"? y/n : n (选择 no)
enable "ignore system config info"? y/n : n (选择 no)
change console baud rate? y/n : y (选择 yes)
enter rate: 0 = 9600, 1 = 4800, 2 = 1200, 3 = 2400,
4 = 19200, 5 = 38400, 6 = 57600, 7 = 115200 : 0 (选择0改回用标准速率速率9600的xmodem传输)
change the boot characteristics? y/n : n (选择 no)
Configuration Summary
enabled are:
load rom after netboot fails
console baud: 9600
boot: image specified by the boot system commands
or default to: cisco2-C2600
do you wish to change the configuration? y/n : n (选择 no)
You must reset or power cycle for new config to take effect
rommon 2 > reset
===================================================================
页:
[1]