cisco路由器上实现的CHAP认证
一、Router1的配置如下： Router>enableRouter#configure terminal
Enter configuration commands, one per line.End with CNTL/Z.
Router(config)#hostname Router1
Router1(config)#interface ethernet 0/0
Router1(config-if)#ip address 192.168.10.1 255.255.255.0
Router1(config-if)#no shutdown
%LINK-3-UPDOWN: Interface Ethernet0/0, changed state to up
Router1(config-if)#exit
Router1(config)#interface serial 0/0
Router1(config-if)#ip address 10.10.10.1 255.255.255.252
Router1(config-if)#clock rate 64000
Router1(config-if)#no shutdown
%LINK-3-UPDOWN: Interface Serial0/0, changed state to up
%LINK-3-UPDOWN: Interface Serial0/0, changed state to down
%LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0/0, changed state to down
Router1(config-if)#exit
%LINK-3-UPDOWN: Interface Serial0/0, changed state to up
%LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0/0, changed state to up
Router1(config)#ip route 192.168.20.0 255.255.255.0 10.10.10.1
Router1(config)#username Router2 password cisco
Router1(config)#interface serial 0/0
Router1(config-if)#encapsulation ppp
%LINK-3-UPDOWN: Interface Serial0/0, changed state to down
%LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0/0, changed state to down
Router1(config-if)#ppp authentication chap
Router1(config-if)#exit
Router1(config)#exit
Router1#copy running-config startup-config
Destination filename ?
Building configuration...
%LINK-3-UPDOWN: Interface Serial0/0, changed state to up
%LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0/0, changed state to up
页:
[1]