LVS/DR结合keepalived
LVS/DR 配置准备3台机器：
dir(192.168.220.141)
rs1(192.168. 220.143)
rs2(192.168.220.144)
vip(192.168.220.110)
Director 上 vim /usr/local/sbin/lvs_dr.sh //增加
#! /bin/bash
echo 1 > /proc/sys/net/ipv4/ip_forward
ipv=/sbin/ipvsadm
vip=192.168.220.110
rs1=192.168.220.143
rs2=192.168.220.144
ifconfig eth0:0 $vip broadcast $vip netmask 255.255.255.255 up
route add -host $vip dev eth0:0
$ipv -C
$ipv -A -t $vip:80 -s rr
$ipv -a -t $vip:80 -r $rs1:80 -g -w 1
$ipv -a -t $vip:80 -r $rs2:80 -g -w 1
两台rs上：vim /usr/local/sbin/lvs_dr_rs.sh
#! /bin/bash
vip=192.168.220.110
ifconfig lo:0 $vip broadcast $vip netmask 255.255.255.255 up
route add -host $vip lo:0
echo "1" >/proc/sys/net/ipv4/conf/lo/arp_ignore
echo "2" >/proc/sys/net/ipv4/conf/lo/arp_announce
echo "1" >/proc/sys/net/ipv4/conf/all/arp_ignore
echo "2" >/proc/sys/net/ipv4/conf/all/arp_announce
然后director上执行: bash /usr/local/sbin/lvs_dr.sh
两台rs上执行: bash /usr/local/sbin/lvs_dr_rs.sh
Windows下浏览器测试访问
结合keepalived
再准备一台机器作为备用dir(192.168.220.129)
在主dir上
vim /etc/keepalived/keepalived.conf
vrrp_instance VI_1 {
state MASTER #备用服务器上为 BACKUP
interface eth0
virtual_router_id 51
priority 100#备用服务器上为90
advert_int 1
authentication {
auth_type PASS
auth_pass 1111
}
virtual_ipaddress {
192.168.220.110
}
}
virtual_server 192.168.220.110 80 {
delay_loop 6 #(每隔10秒查询realserver状态)
lb_algo wlc #(lvs 算法)
lb_kind DR #(Direct Route)
persistence_timeout 60 #(同一IP的连接60秒内被分配到同一台realserver)
protocol TCP #(用TCP协议检查realserver状态)
real_server 192.168.220.143 80 {
weight 100 #(权重)
TCP_CHECK {
connect_timeout 10 #(10秒无响应超时)
nb_get_retry 3
delay_before_retry 3
connect_port 80
}
}
real_server 192.168.220.144 80 {
weight 100
TCP_CHECK {
connect_timeout 10
nb_get_retry 3
delay_before_retry 3
connect_port 80
}
}
}
scp /etc/keepalived/keepalived.conf 192.168.220.129://etc/keepalived/keepalived.conf
在备用dir上
vim /etc/keepalived/keepalived.conf
修改以下几处：
state MASTER-> state BACKUP
priority 100 -> priority 90
配置完keepalived后，需要开启端口转发（主从都要做）：
echo 1 > /proc/sys/net/ipv4/ip_forward
然后，两个rs上执行 /usr/local/sbin/lvs_dr_rs.sh 脚本
最后，两个director上启动keepalived服务（先主后从）：
/etc/init.d/keepalived start
另外，需要注意的是，启动keepalived服务会自动生成vip和ipvsadm规则，不需要再去执行上面提到的/usr/local/sbin/lvs_dr.sh 脚本。
页:
[1]