vivion34 发表于 2015-5-24 12:11:16

CISCO IOS Command(tunnel)

r1(config)#int tunnel 0
r1(config-if)#?
Interface configuration commands:
access-expression       Build a bridge boolean access expression
appletalk               Appletalk interface subcommands
arp                     Set arp type (arpa, probe, snap) or timeout
backup                  Modify backup parameters
bandwidth               Set bandwidth informational parameter
carrier-delay         Specify delay for interface transitions
cdp                     CDP interface subcommands
clns                  CLNS interface subcommands
crypto                  Encryption/Decryption commands
ctunnel               CLNP tunneling
decnet                  Interface DECnet config commands
default               Set a command to its defaults
delay                   Specify interface throughput delay
description             Interface specific description
dspu                  Down Stream PU
exit                  Exit from interface configuration mode
fras                  DLC Switch Interface Command
help                  Description of the interactive help system
hold-queue            Set hold queue depth
ip                      Interface Internet Protocol config commands
ipx                     Novell/IPX interface subcommands
isis                  IS-IS commands
iso-igrp                ISO-IGRP interface subcommands
lan-name                LAN Name command
lat                     LAT commands
llc2                  LLC2 Interface Subcommands
load-interval         Specify interval for load calculation for an
                        interface
locaddr-priority      Assign a priority group
logging               Configure logging for interface
mac-address             Manually set interface MAC address
max-reserved-bandwidthMaximum Reservable Bandwidth on an Interface
mtu                     Set the interface Maximum Transmission Unit (MTU)
multilink-group         Put interface in a multilink bundle
netbios               Use a defined NETBIOS access list or enable
                        name-caching
no                      Negate a command or set its defaults
ntp                     Configure NTP
rate-limit            Rate Limit
rmon                  Configure Remote Monitoring on an interface
sap-priority            Assign a priority group
service-policy          Configure QoS Service Policy
shutdown                Shutdown the selected interface
smrp                  Simple Multicast Routing Protocol interface
--More--
03:38:32: %LINEPROTO-5-UPDOWN: Line protocol on Interface Tunnel0, changed state to down
                        subcommands
sna                     SNA pu configuration
snapshot                Configure snapshot support on the interface
snmp                  Modify SNMP interface parameters
tarp                  TARP interface subcommands
timeout               Define timeout values for this interface
traffic-shape         Enable Traffic Shaping on an Interface or
                        Sub-Interface
transmit-interface      Assign a transmit interface to a receive-only
                        interface
tunnel                  protocol-over-protocol tunneling
tx-ring-limit         Configure PA level transmit ring limit
vines                   VINES interface subcommands
xns                     XNS interface subcommands
页: [1]
查看完整版本: CISCO IOS Command(tunnel)