RedHat下建立群集

stcaac

　　Enter cluster name  Cluster:Cluster
　　Enter IP address for cluster alias [x.x.x.x]: 10.0.0.3
　　--------------------------------
　　Information for Cluster Member 0
　　--------------------------------
　　Enter name of cluster member [storage0]: node1
　　Looking for host storage0 (may take a few seconds)...
　　Enter number of heartbeat channels (minimum = 1) [1]: 1
　　Information about Channel 0
　　Channel type: net or serial [net]:
　　Enter hostname of the cluster member on heartbeat channel 0 \

[node1]: node1

　　Looking for host node1 (may take a few seconds)...
　　Information about Quorum Partitions
　　Enter Primary Quorum Partition [/dev/raw/raw1]: /dev/raw/raw1
　　Enter Shadow Quorum Partition [/dev/raw/raw2]: /dev/raw/raw2
　　Information About the Power Switch That Power Cycles Member ’storage0’
　　Choose one of the following power switches:
　　o NONE
　　o RPS10
　　o BAYTECH
　　o APCSERIAL
　　o APCMASTER
　　o WTI_NPS
　　Power switch  NONE: NONE
　　Information for Cluster Member 1
　　--------------------------------
　　Enter name of cluster member [node2]: node2
　　Looking for host storage1 (may take a few seconds)...
　　Information about Channel 0
　　Enter hostname of the cluster member on heartbeat channel 0 \

[node2]: node2

　　Looking for host storage1 (may take a few seconds)...
　　Information about Quorum Partitions
　　Enter Primary Quorum Partition [/dev/raw/raw1]: /dev/raw/raw1
　　Enter Shadow Quorum Partition [/dev/raw/raw2]: /dev/raw/raw2
　　Information About the Power Switch That Power Cycles Member ’node2’
　　Choose one of the following power switches:
　　o NONE
　　o RPS10
　　o BAYTECH
　　o APCSERIAL
　　o APCMASTER
　　o WTI_NPS
　　Power switch  NONE: NONE
　　Cluster name: Development Cluster
　　Cluster alias IP address: 10.0.0.154
　　Cluster alias netmask: 255.255.254.0
　　--------------------
　　Member 0 Information
　　--------------------
　　Name: node1
　　Primary quorum partition: /dev/raw/raw1
　　Shadow quorum partition: /dev/raw/raw2
　　Heartbeat channels: 1
　　Channel type: net, Name: node1
　　Power switch IP address or hostname: node1
　　--------------------
　　Member 1 Information
　　--------------------
　　Name: node2
　　Primary quorum partition: /dev/raw/raw1
　　Shadow quorum partition: /dev/raw/raw2
　　Heartbeat channels: 1
　　Channel type: net, Name: node2
　　Save the cluster member information? yes/no [yes]:
　　Writing to configuration file...done
　　Configuration information has been saved to /etc/cluster.conf.
　　----------------------------
　　Setting up Quorum Partitions
　　----------------------------
　　Running cludiskutil -I to initialize the quorum partitions: done
　　Saving configuration information to quorum partitions: done
　　Do you wish to allow remote monitoring of the cluster? yes/no \

[yes]: yes

　　----------------------------------------------------------------
　　Configuration on this member is complete.
　　To configure the next member, invoke the following command on that system:
　　# /sbin/cluconfig --init=/dev/raw/raw1
　　See the manual to complete the cluster installation
　　3