SRX与Cisco之间的port-channel配置

lukyjyt

Cisco与SRX之间的port-channel配置：【两都可以配置为on模式、也可以利用LACP配置为双active或者是一端active一段passive】
方法一：
Cisco配置：
CORE-SW#show running-config interface gigabitEthernet 0/35
Building configuration...
Current configuration : 92 bytes
!
interface GigabitEthernet0/35
no switchport
no ip address
channel-group 1 mode on
end
CORE-SW#show running-config interface gigabitEthernet 0/36
Building configuration...
Current configuration : 92 bytes
!
interface GigabitEthernet0/36
no switchport
no ip address
channel-group 1 mode on
end
CORE-SW#show running-config interface port-channel 1
Building configuration...
Current configuration : 85 bytes
!
interface Port-channel1
no switchport
ip address 10.10.10.1 255.255.255.252
end
SRX配置：
lab# show interfaces fe-0/0/2
fastether-options {
    802.3ad ae0;
}
[edit]
lab# show interfaces fe-0/0/3
fastether-options {
    802.3ad ae0;
}
[edit]
lab# show interfaces ae0
unit 0 {
    family inet {
        address 10.10.10.2/30;
    }
}
[edit]
方法二：
CORE-SW#show running-config interface gigabitEthernet 0/35
Building configuration...
Current configuration : 119 bytes
!
interface GigabitEthernet0/35
no switchport
no ip address
channel-protocol lacp
channel-group 1 mode active
end
CORE-SW#show running-config interface gigabitEthernet 0/36
Building configuration...
Current configuration : 119 bytes
!
interface GigabitEthernet0/36
no switchport
no ip address
channel-protocol lacp
channel-group 1 mode active
end
CORE-SW#show run
CORE-SW#show running-config in
CORE-SW#show running-config interface port-c
CORE-SW#show running-config interface port-channel 1
Building configuration...
Current configuration : 85 bytes
!
interface Port-channel1
no switchport
ip address 10.10.10.1 255.255.255.252
end
SRX配置:
lab> configure
Entering configuration mode
[edit]
lab# show interfaces fe-0/0/2
fastether-options {
    802.3ad ae0;
}
[edit]
lab# show interfaces fe-0/0/3
fastether-options {
    802.3ad ae0;
}
[edit]
lab# show interfaces ae0
aggregated-ether-options {
    lacp {
        passive;
    }
}
unit 0 {
    family inet {
        address 10.10.10.2/30;
    }
}
[edit]