环境:Windows XP GNS3.0.7 SecureCRT(可以不要) ADSL上网账号。 目的: 通过实验学习如何配置让路由进行ADSL拨号连外网 开始: (开始前把ADSL拨号连接断开) 1.打开GNS新建工程构建如下拓扑:
2、配置Cloud “本地连接“:右键“本地连接”选择“配置“进入如下界面后,选择本地连接网卡,然后按“添加”,再按“Apply“ 接着按“OK”:
3、在GNS工具栏中按“添加连接”接着用鼠标把设备连接起来如下 :
4、选中“R1”右键选择“开始”,接着继续选中“R1”右键选择“Console”出现如下界面:(因为环境中把SecureCRT集成进去,所以单击“Console”出现SecureCRT控制台,若果没有集成出现一个DOS窗口)如下:
在SecureCRT中对路由器R1进行基本配置 Router>en Router#conf t Enter configuration commands, one per line. End with CNTL/Z. Router(config)#hostname R1 R1 (config)#enable pass cisco R1 (config)#lin con 0 R1 (config-line)#pass cisco R1 (config-line)#login R1 (config-line)#no exec-timeout R1 (config-line)#logging synchronous R1 (config-line)#exit R1 (config)#line vty 0 15 R1 (config-line)#pass cisco R1 (config-line)#login R1 (config-line)#logg synchronous R1 (config-line)#no exec-timeout R1 (config-line)#exit
5、配置R1开启vpdn功能,命令如下 R1(config)#vpdn enable R1(config)#vpdn-group inner R1(config-vpdn)#request-dialin R1(config-vpdn-req-in)#protocol pppoe R1(config-vpdn-req-in)#exit R1(config-vpdn)#exit R1(config)#
6、配置R1 与“本地连接“相连的接口fa0/0进行拨号 ,命令如下: R1(config)#int fa0/0 R1(config-if)#no ip add R1(config-if)#no sh R1(config-if)#no shutdown R1(config-if)#speed auto R1(config-if)#duplex auto R1(config-if)#pppoe enable R1(config-if)#pppoe-client dial-pool-number 1 R1(config-if)#exit R1(config)#
7、配置逻辑拨号接口:命令如下: R1(config)#interface dialer 1 R1(config-if)#mtu 1492 R1(config-if)#ip address negotiated R1(config-if)#ip nat outside R1(config-if)#encapsulation ppp R1(config-if)#no ip mroute-cache R1(config-if)#dialer pool 1 R1(config-if)#dialer-group 1 R1(config-if)#no cdp enable R1(config-if)#ppp authentication pap callin R1(config-if)#ppp pap sent-username “用户名” password “密码” 8、查看:
|