CISCO升级与恢复方案

nosilence

rommon 2 > confreg　　do you wish to change the configuration? y/n [n]: y
　　enable "diagnostic mode"? y/n [n]: n
　　enable "use net in IP bcast address"? y/n [n]: n
　　disable "load rom after netboot fails"? y/n [n]: n
　　enable "use all zero broadcast"? y/n [n]: n
　　enable "break/abort has effect"? y/n [n]: n
　　enable "ignore system config info"? y/n [n]: n
　　change console baud rate? y/n [n]: y
　　enter rate: 0 = 9600, 1 = 4800, 2 = 1200, 3 = 2400
　　4 = 19200, 5 = 38400, 6 = 57600, 7 = 115200 [7]: 7
　　change the boot characteristics? y/n [n]: y
　　enter to boot:
　　0 = ROM Monitor
　　1 = the boot helper image
　　2-15 = boot system
　　[0]: 0
　　Configuration Summary
　　enabled are:
　　load rom after netboot fails
　　console baud: 115200
　　boot: the ROM Monitor
　　do you wish to change the configuration? y/n [n]: n
　　You must reset or power cycle for new config to take effect
　　rommom 2 > reset