ESX4 通过VMware vSphere CLI 开启snmp

chenqb

　　发现VMware vSphere CLI的功能实在强大，学习中。。。
　　To configure the communities do the following:
　　vicfg-snmp.pl –server  –username  –password  -c .
　　Replace  with the community name you wish to set. Each time you specify a community with this
　　command, the setings you specify overwrite the previous configuration. To specify multiple communities,
　　separate the community names with a comma.
　　For example, to set the communities public and internal on the host host.example.com, you might type
　　vicfg-snmp.pl –server host.example.com –username user –password password -c public,
　　internal.
　　vicfg-snmp.pl –server  –username  –password  -c .
　　Replace  with the community name you wish to set. Each time you specify a community with this
　　command, the setings you specify overwrite the previous configuration. To specify multiple communities,
　　separate the community names with a comma.
　　For example, to set the communities public and internal on the host host.example.com, you might type
　　vicfg-snmp.pl –server host.example.com –username user –password password -c public, internal.
　　To configure the SNMP agent traps do:
　　vicfg-snmp.pl –server  –username  –password  -t @/.
　　Replace , , and  with the address of the target system, the port number
　　to send the traps to, and the community name, respectively. Each time you specify a target with this
　　command, the settings you specify overwrite all previously specified settings. To specify multiple targets,
　　
　　separate them with a comma.
　　For example, to send SNMP traps from the host host.example.com to port 162 on target.example.com using
　　the public community, type
　　vicfg-snmp.pl –server host.example.com –username user –password password -t
　　target.example.com@162/public.
　　Enable the SNMP agent by typing
　　vicfg-snmp.pl –server  –username  –password  –enable.
　　Send a test trap to verify that the agent is configured correctly by typing
　　vicfg-snmp.pl –server  –username  –password  –test.
　　The agent sends a warmStart trap to the configured target.
　　To configure the SNMP agent for polling do:
　　vicfg-snmp.pl –server  –username  –password  -p .
　　Replace  with the port for the embedded SNMP agent to use for listening for polling requests.
　　If the SNMP agent is not enabled, enable it by typing
　　vicfg-snmp.pl –server  –username  –password  –enable.
　　And there you have it SNMP on ESX4i.
　　
　　本人执行以上命令后，结果如下：
　　
Current SNMP agent settings:
Enabled  : 1
UDP port : 161
Communities :
public
Notification targets :
192.168.9.3@162/public
　　/Files/qlight/Configuring_SNMP_on_ESX4.pdf