设为首页 收藏本站
查看: 496|回复: 0

[经验分享] 恢复Cisco交换机的err-disabled端口

[复制链接]

尚未签到

发表于 2018-7-14 07:15:23 | 显示全部楼层 |阅读模式
  2012年7月23日中午登录192.168.15.10思科2960交换机,发现VLAN17的两个端口仍然处于err-disabled状态,下面是解决办法。
  User Access Verification
  Password:
  dabaicai10>enable
  Password:
  dabaicai10#sh int status err-d
  dabaicai10#sh int status err-disabled
  Port      Name               Status       Reason              Err-disabled Vlans
  Gi0/17                       err-disabled   loopback
  Gi0/27                       err-disabled   loopback
  dabaicai10#sh errdisable detect
  ErrDisable Reason      Detection    Mode
  -----------------      ---------    ----
  arp-inspection          Enabled      port
  bpduguard               Enabled      port
  channel-misconfig       Enabled      port
  community-limit         Enabled      port
  dhcp-rate-limit         Enabled      port
  dtp-flap                Enabled      port
  gbic-invalid            Enabled      port
  inline-power            Enabled      port
  invalid-policy          Enabled      port
  link-flap               Enabled      port
  loopback                Enabled      port
  lsgroup                 Enabled      port
  mac-limit               Enabled      port
  pagp-flap               Enabled      port
  port-mode-failure       Enabled      port
  psecure-violation       Enabled      port/vlan
  security-violation      Enabled      port
  sfp-config-mismatch     Enabled      port
  small-frame             Enabled      port
  storm-control           Enabled      port
  udld                    Enabled      port
  vmps                    Enabled      port
  dabaicai10#sh errdisable recovery
  ErrDisable Reason            Timer Status
  -----------------            --------------
  arp-inspection               Disabled
  bpduguard                    Disabled
  channel-misconfig            Disabled
  dhcp-rate-limit              Disabled
  dtp-flap                     Disabled
  gbic-invalid                 Disabled
  inline-power                 Disabled
  link-flap                    Disabled
  mac-limit                    Disabled
  loopback                     Disabled
  pagp-flap                    Disabled
  port-mode-failure            Disabled
  psecure-violation            Disabled
  security-violation           Disabled
  sfp-config-mismatch          Disabled
  small-frame                  Disabled
  storm-control                Disabled
  udld                         Disabled
  vmps                         Disabled
  Timer interval: 300 seconds
  Interfaces that will be enabled at the next timeout:
  dabaicai10#conf t
  Enter configuration commands, one per line.  End with CNTL/Z.
  dabaicai10(config)#errdisable recovery loop
  dabaicai10(config)#errdisable recovery cause loopb
  dabaicai10(config)#errdisable recovery cause loopback //err-disabled端口恢复添加环路这一项
  dabaicai10(config)#errdisable recovery interval 30  //配置超时时间30
  dabaicai10(config)#
  如果没有配置超时恢复功能,或者想在超时之前使端口恢复正常,则需要在端口上shutdown和noshutdown,这样才能让端口恢复到forwarding正常状态。
  dabaicai10#sh errdisable recovery
  ErrDisable Reason            Timer Status
  -----------------            --------------
  arp-inspection               Disabled
  bpduguard                    Disabled
  channel-misconfig            Disabled
  dhcp-rate-limit              Disabled
  dtp-flap                     Disabled
  gbic-invalid                 Disabled
  inline-power                 Disabled
  link-flap                    Disabled
  mac-limit                    Disabled
  loopback                     Enabled
  pagp-flap                    Disabled
  port-mode-failure            Disabled
  psecure-violation            Disabled
  security-violation           Disabled
  sfp-config-mismatch          Disabled
  small-frame                  Disabled
  storm-control                Disabled
  udld                         Disabled
  vmps                         Disabled
  Timer interval: 30 seconds
  Interfaces that will be enabled at the next timeout:
  现在重新查看处于err-disabled状态的端口,没有发现处于此状态的端口,如下:
  dabaicai10#sh int status  err-disabled
  查看17号端口状况:
  dabaicai10#sh int status  err-disabled
  dabaicai10#sh int gi0/17
  GigabitEthernet0/17 is down, line protocol is down (notconnect)
  Hardware is Gigabit Ethernet, address is b8be.bf4e.1f91 (bia b8be.bf4e.1f91)
  MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,

  >  Encapsulation ARPA, loopback not set
  Keepalive set (10 sec)
  Auto-duplex, Auto-speed, media type is 10/100/1000BaseTX
  input flow-control is off, output flow-control is unsupported
  ARP type: ARPA, ARP Timeout 04:00:00
  Last input 1w0d, output 1w0d, output hang never
  Last clearing of "show interface" counters never
  Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
  Queueing strategy: fifo
  Output queue: 0/0 (size/max)
  5 minute input rate 0 bits/sec, 0 packets/sec
  5 minute output rate 0 bits/sec, 0 packets/sec
  93950698 packets input, 71258537104 bytes, 0 no buffer
  Received 434636 broadcasts (56052 multicasts)
  0 runts, 2 giants, 0 throttles
  5 input errors, 3 CRC, 0 frame, 0 overrun, 0 ignored
  0 watchdog, 56052 multicast, 0 pause input
  0 input packets with dribble condition detected
  93836379 packets output, 91682002748 bytes, 0 underruns
  0 output errors, 0 collisions, 3 interface resets
  0 babbles, 0 late collision, 0 deferred
  0 lost carrier, 0 no carrier, 0 PAUSE output
  0 output buffer failures, 0 output buffers swapped out
  查看27号口:
  dabaicai10#sh int gi0/27
  GigabitEthernet0/27 is down, line protocol is down (notconnect)
  Hardware is Gigabit Ethernet, address is b8be.bf4e.1f9b (bia b8be.bf4e.1f9b)
  MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,

  >  Encapsulation ARPA, loopback not set
  Keepalive set (10 sec)
  Auto-duplex, Auto-speed, media type is 10/100/1000BaseTX
  input flow-control is off, output flow-control is unsupported
  ARP type: ARPA, ARP Timeout 04:00:00
  Last input 1w0d, output 1w0d, output hang never
  Last clearing of "show interface" counters never
  Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
  Queueing strategy: fifo
  Output queue: 0/0 (size/max)
  5 minute input rate 0 bits/sec, 0 packets/sec
  5 minute output rate 0 bits/sec, 0 packets/sec
  10364564242 packets input, 5588212311201 bytes, 0 no buffer
  Received 1216372196 broadcasts (16084363 multicasts)
  0 runts, 1 giants, 0 throttles
  36 input errors, 35 CRC, 0 frame, 0 overrun, 0 ignored
  0 watchdog, 16084363 multicast, 0 pause input
  0 input packets with dribble condition detected
  9735409446 packets output, 9222664589218 bytes, 0 underruns
  0 output errors, 0 collisions, 1 interface resets
  0 babbles, 0 late collision, 0 deferred
  0 lost carrier, 0 no carrier, 0 PAUSE output
  0 output buffer failures, 0 output buffers swapped out
  Gi0/17 与Gi0/27均已不是err-disabled状态。

运维网声明 1、欢迎大家加入本站运维交流群:群②:261659950 群⑤:202807635 群⑦870801961 群⑧679858003
2、本站所有主题由该帖子作者发表,该帖子作者与运维网享有帖子相关版权
3、所有作品的著作权均归原作者享有,请您和我们一样尊重他人的著作权等合法权益。如果您对作品感到满意,请购买正版
4、禁止制作、复制、发布和传播具有反动、淫秽、色情、暴力、凶杀等内容的信息,一经发现立即删除。若您因此触犯法律,一切后果自负,我们对此不承担任何责任
5、所有资源均系网友上传或者通过网络收集,我们仅提供一个展示、介绍、观摩学习的平台,我们不对其内容的准确性、可靠性、正当性、安全性、合法性等负责,亦不承担任何法律责任
6、所有作品仅供您个人学习、研究或欣赏,不得用于商业或者其他用途,否则,一切后果均由您自己承担,我们对此不承担任何法律责任
7、如涉及侵犯版权等问题,请您及时通知我们,我们将立即采取措施予以解决
8、联系人Email:admin@iyunv.com 网址:www.yunweiku.com

所有资源均系网友上传或者通过网络收集,我们仅提供一个展示、介绍、观摩学习的平台,我们不对其承担任何法律责任,如涉及侵犯版权等问题,请您及时通知我们,我们将立即处理,联系人Email:kefu@iyunv.com,QQ:1061981298 本贴地址:https://www.yunweiku.com/thread-536916-1-1.html 上篇帖子: H3C、CISCO、华为,telnet的配置 下篇帖子: CISCO网络基础小实验第六节
您需要登录后才可以回帖 登录 | 立即注册

本版积分规则

扫码加入运维网微信交流群X

扫码加入运维网微信交流群

扫描二维码加入运维网微信交流群,最新一手资源尽在官方微信交流群!快快加入我们吧...

扫描微信二维码查看详情

客服E-mail:kefu@iyunv.com 客服QQ:1061981298


QQ群⑦:运维网交流群⑦ QQ群⑧:运维网交流群⑧ k8s群:运维网kubernetes交流群


提醒:禁止发布任何违反国家法律、法规的言论与图片等内容;本站内容均来自个人观点与网络等信息,非本站认同之观点.


本站大部分资源是网友从网上搜集分享而来,其版权均归原作者及其网站所有,我们尊重他人的合法权益,如有内容侵犯您的合法权益,请及时与我们联系进行核实删除!



合作伙伴: 青云cloud

快速回复 返回顶部 返回列表