Cisco 路由器的 IOS

kinila

Router>enable　　Router#reload

　　Proceed with>
　　00:01:04: %SYS-5-RELOAD:>　　System Bootstrap, Version 11.3(2)XA4, RE LEASE SOFTWARE (fc1)
　　Copyright (c) 1999 by cisco Systems, Inc.
　　TAC:Home:SW:IOS:Specials for info
　　PC = 0xfff0a530, Vector = 0x500, SP = 0x680127b0
　　C2600 platform with 24576 Kbytes of  main memory
　　PC = 0xfff0a530, Vector = 0x500, SP = 0x80004684
　　monitor: command "boot" aborted due to user interrupt
　　rommon 1 > confreg
　　Configuration Summary
　　enabled are:
　　load rom after netboot fails
　　console baud: 115200
　　boot: image specified by the boot&n bsp;system commands
　　or default to: cisco2-C2600
　　do you wish to change the conf iguration? y/n [n]: y (选择 yes)
　　enable "diagnostic mode"? y/n [n]: n (选择 no)
　　enable "use net in IP bcast ad dress"? y/n [n]: n (选择 no)
　　disable "load rom after netboot fails"? y/n [n]: n (选择 no)
　　enable "use all zero broadcast"? y/n [n]: n (选择 no)
　　enable "break/abort has effect"? y/n [n]: n (选择 no)
　　enable "ignore system config info"? y/n [n]: n (选择 no)
　　change console baud rate? y/n [n]: y (选择 yes)
　　enter rate: 0 = 9600, 1 = 4800, 2 = 1200, 3 = 2400,
　　4 = 19200, 5 = 38400, 6 = 57600, 7 = 115200 [7]: 0 (选择0改回用标准速率速率9600的xmodem传输)
　　change the boot characteristics? y/n [n]: n (选择 no)
　　Configuration Summary
　　enabled are:
　　load rom after netboot fails
　　console baud: 9600
　　boot: image specified by the boot system commands
　　or default to: cisco2-C2600
　　do you wish to change the configuration? y/n [n]: n (选择 no)
　　You must reset or power cycle for new config to take effect
　　rommon 2 > reset
　　===================================================================