mysql报错Aborted connection 原因和解决思路-官方

nikoo

　　If you start the server with the --log-warnings option, you might find messages like this in your error log:
Aborted connection 854 to db: 'employees' user: 'josh'　　or:
ERROR 1184 (08S01): Aborted connection 17 to db: 'unconnected' user: 'zabbix' host: 'localhost' (init_connect command failed)　　If a client is unable even to connect, the server increments the Aborted_connects status variable. Unsuccessful connection attempts can occur for the following reasons:

• 　　A client attempts to access a database but has no privileges for it.
  
• 　　A client uses an incorrect password.
  
• 　　A connection packet does not contain the right information.
  
• 　　It takes more than connect_timeout seconds to obtain a connect packet. See Section 5.1.4, “Server System Variables”.
  

　　If these kinds of things happen, it might indicate that someone is trying to break into your server! If the general query log is enabled, messages for these types of problems are logged to it.
　　If a client successfully connects but later disconnects improperly or is terminated, the server increments the Aborted_clients status variable, and logs an Aborted connection message to the error log. The cause can be any of the following:

• 　　The client program did not call mysql_close() before exiting.
  
• 　　The client had been sleeping more than wait_timeout or interactive_timeout seconds without issuing any requests to the server. See Section 5.1.4, “Server System Variables”.
  
• 　　The client program ended abruptly in the middle of a data transfer.
  

　　Other reasons for problems with aborted connections or aborted clients:

• 　　The max_allowed_packet variable value is too small or queries require more memory than you have allocated for mysqld. SeeSection B.5.2.10, “Packet Too Large”.
  
• 　　Use of Ethernet protocol with Linux, both half and full duplex. Some Linux Ethernet drivers have this bug. You should test for this bug by transferring a huge file using FTP between the client and server machines. If a transfer goes in burst-pause-burst-pause mode, you are experiencing a Linux duplex syndrome. Switch the duplex mode for both your network card and hub/switch to either full duplex or to half duplex and test the results to determine the best setting.
  
• 　　A problem with the thread library that causes interrupts on reads.
  
• 　　Badly configured TCP/IP.
  
• 　　Faulty Ethernets, hubs, switches, cables, and so forth. This can be diagnosed properly only by replacing hardware.