LVS负载均衡的搭建纯文本

guzan

1.搭建网络环境 （Balancer 01）
[iyunv@localhost ~]# ifconfig eth0
eth0      Link encap:Ethernet  HWaddr 00:0C:29:BD:E7:65  
          inet addr:172.16.10.11  Bcast:172.16.10.255  Mask:255.255.255.0
          inet6 addr: fe80::20c:29ff:febd:e765/64 Scope:Link
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:77849 errors:0 dropped:0 overruns:0 frame:0
          TX packets:510 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000
          RX bytes:56807279 (54.1 MiB)  TX bytes:66326 (64.7 KiB)
          Interrupt:18 Base address:0x2000
eth1      Link encap:Ethernet  HWaddr 00:0C:29:BD:E7:6F  
          inet addr:192.168.10.11  Bcast:192.168.10.255  Mask:255.255.255.0
          inet6 addr: fe80::20c:29ff:febd:e76f/64 Scope:Link
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:199 errors:0 dropped:0 overruns:0 frame:0
          TX packets:72 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000
          RX bytes:30857 (30.1 KiB)  TX bytes:10545 (10.2 KiB)
          Interrupt:16 Base address:0x2080
2.安装ipvsadm管理器
[iyunv@localhost ~]# cd /media/Packages/
[iyunv@localhost Packages]# rpm -ivh ipvsadm-1.25-9.el6.i686.rpm
warning: ipvsadm-1.25-9.el6.i686.rpm: Header V3 RSA/SHA256 Signature, key ID fd431d51: NOKEY
Preparing...                ########################################### [100%]
   1:ipvsadm                ########################################### [100%]
3.配置VIP 脚本，并给予执行权限，然后执行
[iyunv@localhost ~]# vi /opt/vip.sh
#!/bin/bash
#
VIP=192.168.10.19
/sbin/ifconfig eth1:0 $VIP broadcast $VIP netmask 255.255.255.255 up
/sbin/route add -host $VIP dev eth1:0
[iyunv@localhost ~]# chmod +x /opt/vip.sh
[iyunv@localhost ~]# /opt/vip.sh
4.将该脚本加入开机启动项
[iyunv@localhost ~]# echo "/opt/vip.sh" >> /etc/rc.local
[iyunv@localhost ~]# ifconfig eth1:0
eth1:0    Link encap:Ethernet  HWaddr 00:0C:29:BD:E7:6F  
          inet addr:192.168.10.19  Bcast:192.168.10.19  Mask:255.255.255.255
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          Interrupt:16 Base address:0x2080
5.使用ipvsadm命令工具设置DR模式负载均衡群集 （www服务器IP为192.168.10.13-14）
[iyunv@localhost ~]# ipvsadm -A -t 192.168.10.19:80 -s rr
[iyunv@localhost ~]# ipvsadm -a -t 192.168.10.19:80 -r 192.168.10.13 -g
[iyunv@localhost ~]# ipvsadm -a -t 192.168.10.19:80 -r 192.168.10.14 -g
保存ipvsadm设置到/etc/sysconfig/ipvsadm文件以后，下次启动可以直接执行“service ipvsadm start”命令，不再需要逐条输入命令。
[iyunv@localhost ~]# ipvsadm-save > /etc/sysconfig/ipvsadm
[iyunv@localhost ~]# ipvsadm -l
IP Virtual Server version 1.2.1 (size=4096)
Prot LocalAddress:Port Scheduler Flags
  -> RemoteAddress:Port           Forward Weight ActiveConn InActConn
TCP  192.168.10.19:http rr
  -> 192.168.10.13:http           Local   1      0          0         
  -> 192.168.10.14:http           Route   1      0          0   

WWW1的配置
1.配置网络环境
[iyunv@localhost ~]# ifconfig eth0
eth0      Link encap:Ethernet  HWaddr 00:0C:29:FE:39:09  
          inet addr:172.16.10.13  Bcast:172.16.10.255  Mask:255.255.255.0
          inet6 addr: fe80::20c:29ff:fefe:3909/64 Scope:Link
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:23 errors:0 dropped:0 overruns:0 frame:0
          TX packets:58 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000
          RX bytes:5569 (5.4 KiB)  TX bytes:11304 (11.0 KiB)
          Interrupt:59 Base address:0x2024

[iyunv@localhost ~]# ifconfig eth1
eth1      Link encap:Ethernet  HWaddr 00:0C:29:FE:39:13  
          inet addr:192.168.10.13  Bcast:192.168.10.255  Mask:255.255.255.0
          inet6 addr: fe80::20c:29ff:fefe:3913/64 Scope:Link
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:77 errors:0 dropped:0 overruns:0 frame:0
          TX packets:89 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000
          RX bytes:9046 (8.8 KiB)  TX bytes:13582 (13.2 KiB)
          Interrupt:67 Base address:0x20a4
2.在www1上的设置
[iyunv@localhost ~]# vi /opt/lvs-dr //编写lvs-dr脚本
[iyunv@localhost ~]# vi /opt/lvs-dr
#!/bin/bash
VIP=192.168.10.19
/sbin/ifconfig lo:0 $VIP broadcast $VIP netmask 255.255.255.255 up
/sbin/route add -host $VIP dev lo:0
echo "1" > /proc/sys/net/ipv4/conf/lo/arp_ignore
echo "2" > /proc/sys/net/ipv4/conf/lo/arp_announce
echo "1" > /proc/sys/net/ipv4/conf/all/arp_ignore
echo "2" > /proc/sys/net/ipv4/conf/all/arp_announce
3.给予lvs-dr脚本以执行权限，并加入开机启动，然后执行该脚本
[iyunv@localhost ~]# chmod u+x /opt/lvs-dr
[iyunv@localhost ~]# echo "/opt/lvs-dr" >> /etc/rc.local
[iyunv@localhost ~]# /opt/lvs-dr                                                   
4.安装apache网站服务
[iyunv@localhost ~]# mount /dev/cdrom /media/
mount: block device /dev/cdrom is write-protected, mounting read-only
[iyunv@localhost ~]# cd /media/Server/
[iyunv@localhost Server]# rpm -ivh httpd-2.2.3-43.el5.i386.rpm
5.编写基本测试页，并开启httpd服务
[iyunv@localhost Server]# echo "1111" > /var/www/html/index.html
[iyunv@localhost Server]# service httpd restart
停止 httpd：                                               [确定]
启动 httpd：                                               [确定]

WWW2的配置
[iyunv@localhost ~]# ifconfig eth0
eth0      Link encap:Ethernet  HWaddr 00:0C:29:4E:07:88  
          inet addr:172.16.10.14  Bcast:172.16.10.255  Mask:255.255.255.0
          inet6 addr: fe80::20c:29ff:fe4e:788/64 Scope:Link
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:18 errors:0 dropped:0 overruns:0 frame:0
          TX packets:63 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000
          RX bytes:4068 (3.9 KiB)  TX bytes:12063 (11.7 KiB)
          Interrupt:59 Base address:0x2024

[iyunv@localhost ~]# ifconfig eth1
eth1      Link encap:Ethernet  HWaddr 00:0C:29:4E:07:92  
          inet addr:192.168.10.14  Bcast:192.168.10.255  Mask:255.255.255.0
          inet6 addr: fe80::20c:29ff:fe4e:792/64 Scope:Link
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:126 errors:0 dropped:0 overruns:0 frame:0
          TX packets:87 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000
          RX bytes:13293 (12.9 KiB)  TX bytes:12862 (12.5 KiB)
          Interrupt:67 Base address:0x20a4
2.在www2上的设置：将WWW1的lvs-dr脚本传到www2上，并做修改
www1上的操作
[iyunv@localhost Server]# scp /opt/lvs-dr root@192.168.10.14:/opt/
The authenticity of host '192.168.10.14 (192.168.10.14)' can't be established.
RSA key fingerprint is 6e:9d:7a:2d:98:87:46:f1:48:47:f4:04:62:b6:29:4b.
Are you sure you want to continue connecting (yes/no)? yes
Warning: Permanently added '192.168.10.14' (RSA) to the list of known hosts.
root@192.168.10.14's password:
lvs-dr                                                                                       
3.给予lvs-dr脚本以执行权限，并加入开机启动，然后执行该脚本
[iyunv@localhost ~]# chmod u+x /opt/lvs-dr
[iyunv@localhost ~]# echo "/opt/lvs-dr" >> /etc/rc.local
[iyunv@localhost ~]# /opt/lvs-dr
4.安装Apache服务，并编写基本测试页，开启httpd服务
[iyunv@localhost ~]# mount /dev/cdrom /media/
mount: block device /dev/cdrom is write-protected, mounting read-only
[iyunv@localhost ~]# cd /media/Server/
[iyunv@localhost Server]# rpm -ivh httpd-2.2.3-43.el5.i386.rpm
warning: httpd-2.2.3-43.el5.i386.rpm: Header V3 DSA signature: NOKEY, key ID 37017186
Preparing...                ########################################### [100%]
   1:httpd                  ########################################### [100%]
[iyunv@localhost Server]# echo "2222" > /var/www/html/index.html
[iyunv@localhost Server]# service httpd start
启动 httpd：                                               [确定]

jiaxp

恋爱就是无数个饭局，结婚就是一个饭局。

小雪崩

我是来刷分的，嘿嘿

7007

丑，但是丑的特别，也就是特别的丑！

binghai03

啥时硬件也可以COPY就好了!

xsmscb

如果回帖是一种美德，那我早就成为圣人了!

_N_了吧唧的_

帮你顶下哈！！